RANCANG BANGUN SISTEM KONTROL OTOMATIS KOMPOR GAS ELPIJI KONVENSIONAL PADA PROSES PEREBUSAN AIR BERBASIS ARDUINO UNO

  • Fida Jazilatur Rohma

Abstract

Abstrak

Salah satu kegiatan yang berkaitan dengan penggunaan kompor gas elpiji adalah memasak. Memasak terdiri dari beberapa jenis, salah satunya adalah merebus air. Namun, dalam proses perebusan air dapat menimbulkan permasalahan apabila terjadi kelalaian dalam mematikan kompor, diantaranya volume air yang direbus akan menjadi berkurang dan habis, dapat merusak alat masak karena terlalu lama berada di atas kompor, dapat menimbulkan kerugian dalam penggunaan gas elpiji karena tidak efisien dalam penggunaan gas, serta menimbulkan kebakaran.

Penelitian ini dilakukan untuk merancang dan membuat sistem kontrol otomatis pada kompor gas elpiji konvensional dengan jenis kontrol dua posisi (kontrol on-off). Sistem tersebut menggunakan sensor suhu LM35 yang digunakan untuk mendeteksi nilai suhu perebusan air dalam panci. Apabila nilai suhu mencapai nilai setpoint, maka setelah waktu delay 3 menit arduino uno akan memberikan perintah untuk mematikan kompor melalui pergerakan motor servo. Sehingga, dengan adanya sistem kontrol tersebut dapat mengatasi permasalahan akibat kelalaian dalam mematikan kompor.

Dari hasil pengujian diperoleh bahwa saat nilai suhu telah mencapai nilai setpoint, maka setelah delay waktu 3 menit kontroler arduino uno akan mengirimkan sinyal digit 1 ke servo driver untuk mematikan kompor melalui motor servo.

Kata Kunci: Kompor Gas Elpiji Konvensional, Kontrol Dua Posisi (Kontrol On-Off), Sensor Suhu

  LM35, Motor Servo, Arduino Uno

Abstract

One of the activities related to use LPG stove is cooking. Cooking consists of several types, one of them is boiling water. But in the process boiling water may be has created problems if there is negligence in turning off the stove, such as the volume of boiled water will be reduced and exhausted, can damage the cooking utensil because it is too long been on the stove, cause losses in the use of LPG gas because it is not efficient in use of gas, and cause fire.

This research was conducted to design and make automatic control system of conventional LPG stove with two position control type (control on-off). The system uses an LM35 temperature sensor which is used to detect the water boiling temperature value in the pan. If the temperature value reaches the setpoint value, then after 3 minute delay time arduino uno will give command to turn off the stove through servo motor movement. So, with the existence of the control system gas stove can overcome the problem due to negligence in turning off the stove.

From the test results obtained when the value of the setpoint temperature has been reached, then the arduino uno controller will send signal to the servo driver to turn the stove through the servo motor. Whereas, from the results of testing mathematical model, the system can generate response 1,489.

Keywords: Conventional LPG Stove, Two Position Control Type (Control On-Off), LM35 Temperature

   Sensor, Servo Motor, Arduino Uno

Published
2017-06-19
Section
Articles
Abstract Views: 267
PDF Downloads: 575