THE APPLICATION OF NAPHTHALENE SULPHONATED SUPERPLASTICIZER AND CEMENT REDUCER IN NORMAL-STRENGTH CONCRETE

Authors

  • Akhmad Jauhari Alfi Universitas Negeri Surabaya
  • Andang Widjaja Universitas Negeri Surabaya

DOI:

https://doi.org/10.26740/rekats.v14n01.p129-137

Keywords:

Cement Reducer, Compressive strength, Normal-Strength Concrete, Superplas

Abstract

This paper discussed the effect of adding naphthalene sulphonated (NS) superplasticizer (SP) on compressive strength and water reduction in normal-strength concrete with the addition of cement reducer (CR). The mix design followed SNI 7656:2012, using cylindrical specimens sized 15 cm in diameter and 30 cm in height. The cement used was Ordinary Portland Cement from Dynamix, fine aggregate from Lumajang, coarse aggregate from Pasuruan, and water from the Batching Plant Laboratory of PT. Solusi Bangun Beton. The target strength was 30 MPa, with CR added at 0,8%. The variations in the dosage of naphthalene sulfonated superplasticizer were 0.3%, 0.5%, 0.8%, and 1%, with a test age of 28 days for each of the 9 test specimens. The result showed that a gradual water reducing reaching up to 54.26% at a 1% dosage. The average compressive strength of concrete with the addition of 0.8 CR at 28 days of age, with variations of 0%, 0.3%, 0.5%, 0.8%, and 1%, was obtained as 31.3 MPa, 38.7 MPa, 41.5 MPa, 44.00 MPa, and 40.7 MPa, respectively.

Keywords: Cement Reducer, Compressive Strength, Normal-Strength Concrete, Superplasticizer

Downloads

Download data is not yet available.

References

Andika, Yusverison, dan Jessica Debora Dimalouw. 2021. “Pengaruh Penggunaan Sikament® Ln Terhadap Pengurangan Jumlah Kadar Air Dan Kuat Tekan Beton.” Jurnal Karkasa 7(2): 54–61.

Badan Standardisasi Nasional. 2012. “Tata Cara Pemilihan Campuran untuk Beton Normal, Beton Berat dan Beton Massa.” Badan Standardisasi Nasional: 52. www.bsn.go.id.

Bediako, Mark, dan Timothy Kofi Ametefe. 2024. “Effect of sulphonated naphthalene formaldehyde superplasticizer on the mechanical and durability properties of concrete produced using locally sourced fine aggregate from Ghana.” Journal of the Ghana Institution of Engineering 24(1): 41–51.

Dewi, Frida Mustika, Mirza Ghulam Rifqi, dan Muhammad Hilmy. 2022. “Pengaruh Penambahan Zat Aditif Tipe F (Superplasticizer) Dengan Variasi Pengurangan Air Terhadap Nilai Kuat Tekan Pada Mortar.” Jurnal Riset Teknik Sipil Dan Sains 1(1): 20–27.

Dzikri, Muhammad, dan Mochamad Firmansyah Sofianto. 2018. “Pengaruh Penambahan Superplasticizer Pada Beton Dengan Limbah Tembaga (Copper Slag) Terhadap Kuat Tekan Beton Sesuai Umurnya.” Rekayasa Teknik Sipil 2(2/REKAT/18).

Faqihuddin, Abdullah, Hermansyah Hermansyah, dan Eti Kurniati. 2021. “Tinjauan Campuran Beton Normal dengan Penggunaan Superplasticizer Sebagai Bahan Pengganti Air Sebesar 0%; 0, 3%; 0; 5% Dan 0, 7% Berdasarkan Berat Semen.” Journal of Civil Engineering and Planning (JCEP) 2(1): 34–45.

Foulhudan, Joerda, Dwi Nurtanto, dan Krisnamurti Krisnamurti. 2022. “Perbandingan Mix Design SNI 03-2834-2000 dan SNI 7656: 2012 Ditinjau dari Proses Pengecoran Beton Normal.” Jurnal Riset Rekayasa Sipil 5(2): 98–107.

Layang, Samuel, dan Henra Hartako. 2023. “VARIATION OF SUPERPLASTICIZER AMOUNT ON CONCRETE COMPRESSIVE STRENGTH.” BALANGA: Jurnal Pendidikan Teknologi dan Kejuruan 11(2): 117–23.

Mohamad, Nabilla, Khairunisa Muthusamy, Rahimah Embong, Andri Kusbiantoro, dan Mohd Hanafi Hashim. 2022. “Environmental impact of cement production and Solutions: A review.” Materials Today: Proceedings 48: 741–46.

Mulyono, Tri. 2003. Teknologi Beton. Yogyakarta: Andi Offset.

Patil, Somraj S, Rajvardhan N Khochare, Rajvardhan P Gondil, dan Mayur M Maske. 2019. “Review on admixture for civil engineer.” Indonesian Journal of Multidiciplinary Research 1(2): 363–78.

PT. Kimia Konstruksi Indonesia. 2021. Brosur Superplasticizer. Sidoarjo.

PT. Kimia Konstruksi Indonesia. 2025. Brosur Cement Reducer. Sidoarjo.

Riwayati, Susi, dan Andri Agusti. 2021. “PENGARUH PENAMBAHAN SUPER PLASTICIZER KEDALAM CAMPURAN BETON TERHADAP KUAT TEKAN BETON K-400 PADA UMUR 28 HARI.” TEKNIKA: Jurnal Teknik 8(1): 77–84.

Sharma, Ujjwal, Nakul Gupta, dan Kuldeep K Saxena. 2021. “Comparative study on the effect of industrial by-products as a replacement of cement in concrete.” Materials Today: Proceedings 44: 45–51.

Slat, Ventje Berty, Steve W M Supit, dan Noldie Kondoj. 2021. “Pengaruh Superplasticizer Polymer Terhadap Kuat Tekan Beton Mutu Tinggi.” Wahana Teknik Sipil: Jurnal Pengembangan Teknik Sipil 26(2): 115–23.

Sulianti, Ika, Lina Flaviana Tilik, Djaka Suhirkam, Muhammad Prawira Wardana, dan Iros Milawati. 2022. “Pengaruh Penambahan Serat Kawat Bendrat Terhadap Kuat Lentur Beton Geopolimer.” Jurnal Teoritis dan Terapan Bidang Rekayasa Sipil (BENTANG).

Umiati, Sri. 2019. “PENGARUH PENAMBAHAN SUPERPLASTICIZER TERHADAPKUAT TEKAN BETON.” PROSIDING 6 TH ACE CONFERENCE JURUSAN TEKNIK SIPIL UNIVERSITAS ANDALAS.

Widjaja, Andang, dan Yogi Risdianto. 2023. “The Compressive Strength of Concrete Containing Additive as Cement Reducer.” In Proceedings of Vocational Engineering International Conference, , 26–29.

Yanti, Gusneli, dan Shanti Wahyuni Megasari. 2020. “Variation Analysis Addition of Admixture Consol N10 MB to Concrete Compressive Strength.” In IOP Conference Series: Earth and Environmental Science, IOP Publishing, 12031.

Downloads

Published

2026-01-10

Issue

Section

Articles
Abstract views: 0 , PDF Downloads: 0